![]() ![]() Note: You must restart Wysiwyg after making this change. Ensure that "Allow EDMX reception" is ticked, and that the ETCNet2 Version is set to V4. ![]() In the Options menu of Wysiwyg, select Application Options and then navigate to the ETC Interface tab. ![]() WYSIWYG can receive Net2 (EDMX) levels via ethernet. Navigate to Connectivity -> Networks -> AllĪssign WYSIWYG universes to the sACN universes WYSIWYG can receive sACN levels via ethernet. Capture is available for download from the Capture website, Connecting to Wysiwyg Note that you may need to install the Capture application in order to use its network adaptor selection tools. You should see both BSR E1.31 and ETCNet2 Universes, assuming you have any dimmers patched on your console.Ĭapture executable (presentation) files should also receive these network levels. In the Project Window, you will see a tab showing Universes. This means a standalone PC will require either an active connection to an ethernet switch or the "Loopback Adapter" to be installed.įollowing a restart, open your existing project or start a new one. Be sure to set the proper IP address for each of the protocols that you are using.Ī valid network link is required to receive sACN, even if the source is another application on the same PC. In Capture Argo, each protocol can have its own IP address selection. Note that depending upon your PC's configuration, a setting of Automatic may not work in this case select the appropriate adapter. Navigate to the Connectivity tab, and select your network interface card if required. In the Tools menu of Capture, select Options. Capture can receive many protocols including Net2 (EDMX) and Net3 (sACN/E1.31) levels via ethernet.Ĭapture Polar and Capture Argo receive "ratified" sACN/E1.31. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |